Beachcomber 538 Betriebsanleitung PDF herunterladen (Seite 4)

Important Safety Instructions

A green colored terminal, or wire connector

marked Ground is provided within the control

box. To reduce the risk of electric shock, connect

this terminal or connector to the grounding

terminal of the electric service or supply panel

with a continuous copper wire equivalent in

size to the circuit conductors supplying this

equipment. In addition bonding lugs are

provided and marked Bonding Lugs. To reduce

the risk of electric shock, connect the bonding

lugs in accordance with the local electric code.

At least two lugs marked Bonding Lugs are

provided on the external surface of the supply

terminal box. To reduce the risk of electrical

shock connect the local common binding grid in

the area of the hot tub to these terminals with an

insulated or bare copper conductor not smaller

than No.6 AWG. Note: this is factory installed.

All ﬁeld-installed metal components such as

rails, ladders, drains or other similar hardware

within 10 ft(3m) of the hot tub shall be bonded

to the equipment grounding bus with copper

conductors not smaller than #6AWG.

CAUTION: WIRING CONNECTED IN THIS BOX

MUST BE RATED AT 600V.

There are no user serviceable parts within

the management system. The high voltage

can cause injury or death. The hot tub must

be hooked up to a Ground Fault Circuit

Interrupter (G.F.C.I.) by a licensed electrician.

Use the test button on your G.F.C.I. monthly to

ensure it is working properly.

Always make sure there is an adequate sanitizer

level in your hot tub before entering. Failure to

do so may cause skin irritations or illness. Use a

test kit or test strips to check prior to entry.

CAUTION: WATER TEMPERATURE IN EXCESS OF

100ºF/38ºC MAY BE INJURIOUS TO YOUR HEALTH.

AVOID PROLONGED EXPOSURE TO HOT WATER.

WATER TEMPERATURE MAY NEED TO BE DECREASED

FOR CHILDREN OR THE ELDERLY.

THE MAXIMUM RECOMMENDED TEMPERATURE OF

YOUR HOT TUB WATER IS 104ºF/40ºC.

To reduce the risk of drowning from hair and

body entrapment, install suction ﬁtting(s) with

a marked ﬂow rate that is not less than the ﬂow

rate marked on the remote packaged unit. Note:

these are factory installed. Do not operate the hot

tub with any of the suction ﬁtting covers off.

These covers prevent hair or objects from being

sucked into the plumbing. See ﬁgure 1.

IMPORTANT! READ AND FOLLOW ALL

INSTRUCTIONS AND KEEP FOR EASY

REFERENCE.

WARNING

ﬁgure 1

1 2 3 4 5 6 7 8 9 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Beachcomber 538 Betriebsanleitung Seite 4

Kommentare zu diesen Handbüchern